This $20 Gadget makes Oil Changes SUPER EASY (Audi S3 Rebuild)

1. Link for the pump is in the description box!

2. “Oh nooo fuck!” 😂😂😂 I died

3. Audi S7 has the filter and the drain on the under side of the engine. this only makes sense when your filter is on top.

4. hello. how long is the hose that goes into the crankcase cause I bought a different unit and the hose feels like it's to short

5. Hengst is the Audi original filter. Look at the filter in the Audi package and you se its marked VW/Audi and Hengst.

6. I did it many times and I enjoy it too…

7. Oil change starts at minute 4:34

8. How is the pump holding up? Does it still work?

9. Saves you the hassle/money on washers and plugs

10. I prefer letting gravity ensure all oil and shit have left the pan.

11. You could just turn the pump around, and vacuum new oil into the car, and avoid pouring…

12. i have a bmw x5 2004 3.0. the battery is located in the trunk but it has the jump connections in the front. will the device still work?

13. I use it on the Maserati and you get more out if you do it correctly

14. The one for the golf r is plastic too and you only need a flathead! It’s actually really nice, but I’m trying to do the same thing. Thanks for the vid!

15. Use you topsider as a container for your used engine oil.

16. First 4:12 is a total waste of time. And the last 6 minutes could have been done in 2 or 3. Downvoted for that reason.

17. You always talk way to long before getting to the point and that earns you a thumbs down.

18. "OH NO! FUCK!"

19. Hengst is the filter brand of choice for classic Mercedes

20. I haven't used one but I would worry about not being able to inspect/clean the sump plug magnet. (if fitted)

21. Pumps like this are great when you have a transmission pan that doesn't have a drain plug.

22. its like watch harvest moon with cars

23. I've had one of these little pumps for three yrs.. Used to to remove engine oil.. power steering fluid.. and transmission fluid, no problem.

24. Newer Audi's removed the dipsticks too… I added one back. I don't trust the on board electronic oil level display

25. Thought I would just be better to let gravity pull all the shit out as it drains.

26. Fucking shit music..

27. 4:12

28. Depends on the engine, pan design, and where the oil is sucked from.

29. 28 $ joke
    AliExpress twice less expensive this junk

30. The oil drain plug is exactly that allen key or star head wrench or what ever its called lol screw it out drain oil screw it back in

31. Wow how big is your house nice

32. So… the car takes a little bit under 6 quarts (6:03) but what a surprise when all the oil doesn't fit into a gallon and a half of containers (7:01)…. Really?????

33. The "$20 gadget" is $37!

34. Pardon me for posting to an old video.

    I've used a Topsider and if I keep the seals wet with oil and make sure they're in the proper position on the pump, it takes about 3 reps to pump it 30-40 times to get out all 8 qts of oil on the larger sumps.

    The reasoning for using a dipstick extractor is the amount of oil left in the sump. If you've ever seen the inside of an oil pan, most likely you will have noticed the oil drain plug section of the pan is actually thicker than the pan, so it sticks up a tad, leaving a bit of oil (up to 1 qt depending upon the model of any car) in the pan after draining it out via the drain plug. Using the dipstick extraction method (choose your favorite as there are LOTS of them on the market), you get that extra bit of oil out of the pan.

    Now, there are always exceptions, especially if you have 2 separate sumps in the pan (usually to go over things like the sway bar, FWD or front AWD components and the like), and in which case, the sumps are connected by a pump to keep the oil flowing and evenly distributed. In that case, there are usually separate drain plugs with bolts, so the dipstick extraction would only work on the sump where the dipstick inserts into. None of my cars have ever had this 2-part oil pan.

    I have a stainless steel pan which my father-in-law made for draining coolant, so I use that pan to prevent a mess in the garage.

    Oh, Sam… use the Topsider container to pump the oil into and you won't have to go out to locate another container. I believe it holds 2.5 gallons.

Comments are closed.