Since the XOR team is running a fuel injected Coyote motor in the PreRunner Ranger, there are a few things they have to consider when installing the exhaust. The first is finding the correct location for 2 oxygen sensors and also how to weld two pieces of pipe together seamlessly.

A tip for holding the pipe together perfectly straight while working under your work is to grab a piece of angle iron, slide on two hose clamps, and tighten them down. By keeping the exhuast tube perfectly aligned, it makes welding a whole lot easier. A general rule of thumb, as the pipe size gets bigger, use a bigger piece of angle iron.

When it comes to placing the oxygen sensors, the bunghole needs to be in the collector which takes the reading from all 4 of the exhaust tubes. Drill a hole and weld around it 100% so it seals and doesn’t throw off the reading of your oxygen sensors. Be sure to use anti-seize on the threads and torque it down to the recommended specs.

Websites:

https://www.PowerNationTV.com
https://www.PowerBlockTV.com

Facebook Pages:

PowerNation – https://www.facebook.com/PowerNationTV
PowerBlock – https://www.facebook.com/PowerBlockTV
PowerNation Daily – https://www.facebook.com/PowerNationDaily
Detroit Muscle – https://www.facebook.com/DetroitMuscleTV
Engine Power – https://www.facebook.com/EnginePowerTV
Truck Tech – https://www.facebook.com/TruckTechTV
Xtreme Off Road – https://www.facebook.com/XtremeOffRoadTV

Twitter:

PowerNation – https://www.twitter.com/PowerNationTV
PowerBlock – https://www.twitter.com/PowerBlockTV

Instagram:

PowerNation – @PowerNationTV
PowerBlock – @PowerBlockTV

For more on PowerNation, check out PN+ at http://bit.ly/2oTCIyJ

source

By carmodpros

ANGELHOUSE | 2009 - 2022 | HOSTING BY PHILLYFINEST369 SERVER STATS| THE IDIOTS ROBOT AND CONTROL INC. |(RSS FEED MODULE)| ALL YOUTUBE VIDEOS IS A REGISTERED TRADEMARK OF GOOGLE INC. THE YOUTUBE CHANNELS AND BLOG FEEDS IS MANAGED BY THERE RIGHTFUL OWNERS (CARMODPROS,COM)