In this video I tested Seafoam. I use a mini borescope camera to look into the engine and see how dirty the engine is before the fuel treatment and then after the fuel treatment.
I followed the instructions on the container and seafoam did a great job cleaning a good amount of carbon off the piston head. I then filled the cylinder with seafoam and it cleaned out 99% of the carbon! After this test, I would recommend seafoam to clean out small engines. I am impressed by the results and finally we have proof that seafoam actually works!
Does Seafoam Work in a Car Engine?:
Here is the fuel cleaner I used: http://amzn.to/272sWtA
Here is the borescope camera I used: https://amzn.to/2SqMwyH
Royal Purple Max Clean Test: https://www.youtube.com/watch?v=BocH2c4mYcc
Gumout Test: https://www.youtube.com/watch?v=5SoZnymBSC8
Seafoam Test in a Car: https://www.youtube.com/watch?v=u6UeJXkzDW8
Techron Test: https://www.youtube.com/watch?v=h8i9qftqKNY
Lucas Deep Clean Test: https://www.youtube.com/watch?v=FLhXqgEEYyI
CleanBoost Maxx Test: https://www.youtube.com/watch?v=VDUogAQzLAc
Become a ChrisFix Subscriber→ http://www.youtube.com/subscription_center?add_user=paintballoo7
Instagram→ https://www.instagram.com/chrisfixit
Facebook→ https://www.facebook.com/chrisfix8
Website → http://www.ChrisFixed.com
My Channel Home Page → https://www.youtube.com/ChrisFix
**If the video was helpful, remember to give it a “thumbs up” and consider subscribing. New videos every Thursday**
Disclaimer:
Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.
You forgot to tell viewers to change the oil and get that carbon out of the crankcase after treating the upper engine
meh
Good stuff! The trick is to put it in your gas tank and after a while your whole system will be cleaned out, carburetor etc. Bad part kkinda expensive in your car but bikes, small engines, works good every 2 or 3 tanks once the system is cleaned out. Like my bike group used to say, nothing happens using sea foam meaning it keeps running clean like when ya bought it n your carb dont get all gummed up.
I use Lucus Fuel treatment in the gas for years and Seafoam is GREAT too in the ⛽ gas. Good video for sure !!!
So you seafoamed 2 different hondas.
Chrisfix validates the testing that Project Farm did (and made me a fan of Seafoam).
I use Seafoam in my fuel tank at every oil change and plan to flush the crankcase on my golf cart the next time that I change the oil. If you pay attention to sale prices you can get it for $7 a bottle.
THANKS—5670
I NEVER EVER USED THIS STUFF….BUT, I recently had a lawn mower which pushed out SOOOO MUCH SMOKE…I had to shut it down…in fear the neighbors would complain then, a local automotive store says, try seafood…it might loosen the rings…put some in the fuel tank and crankcase… within 2 days and hmmm 10 startups…NO MORE SMOKE
Maybe Chrisfix should buy a carbureted car for his next project… nudge nudge wink wink… 😉
Great video, and quite informative.
This is NOT a Honda engine, as mentioned in the beginning of the video. The lawn mower is a Craftsman. There’s a reason why Craftsman is no longer in business. The company started well enough but eventually produced some real crap and people caught on to this… Honda makes some some rather die hard engines. My Craftsman died after about ten or twelve years. The Honda mower I currently use is about 18-19 years old (no shit) and still runs well.
cAN'T FIND THE VIDEO OF YOUR mARVEL mYSTERY oIL TEST.
My dad and I always get into it because he is a marvel mystery oil guy and I'm a die hard sea foam guy
Load a shit !
You put the sea foam in the gas
You’ll get a similar result with plain old tap water.
Not enough to make a big difference
I mix seafoam in my lawn mower gas tank everytime I fill it up.
It's Ed from Northern Exposure (sounds like).
Just put The gas additive Sta-bil and use Lucas, top cylinder lubricate
Your supposed to put it in your gas tank not your intake
Damn dude. What about all that seafoam your lungs took in?
I got to try this on my lawn mower. I have had good luck with it in my car
Cool
Very unimpressive. Why not use water
thats dirty ?
How long will it take to cut a half acre of grass with a hedge clippers
Your neighbours know you are using sea foam
I put into the my gas can. My blower and mower start every season.
Seafoam. Seafoam Seafoam, me thinks you're sponsored by Seafoam.
Absolute scam
I never forget a friend puting old engine oil in my mower .5 muinuts later the piston shot out the side like a bullet just missing my leg my eyes cought it .never again.
Will Sea Foam work to unclog partially plugged jets in a carbureted 2 stroke outboard when run in the fuel?
This video should be named (how to fix a honda civic)😂
The piston still looks bad…..and that was a 1 cylinder engine that you used as much Sea Foam on as a mulitcylinder engine….right?
I have no affiliation with seafoam . Problem 1990 wave runner 2 stroke 650cc not started in 4 years. Tried an entire can of carb cleaner, ignition spray over several days, no luck. While digging around for some other chem Solution , I found an almost empty can of seafoam, about a 1/4 cup . Poured it down carb and waited for 3 hours . It started on the first try. I had already located a carb rebuild kit for it , this was my last attempt before pulling the carb
this appeared in my recommended
Carbon raises the compression that is lost due to wear. 🙂
Nice video
I wonder if you ran it through the gas tank like you are supposed to do it would be cleaning for 1/2 to 1 hour while cutting grass ?
Holy fk dude
Amazing process!